Télécharger Imprimer la page

Preventive Maintenance - Laundrylux CROSSOVER Serie Manuel D'installation

Publicité

Les langues disponibles

Les langues disponibles

To keep your machine in proper working order, follow the preventive maintenance
recommendations provided below.
The maintenance interval should be adjusted according to machine usage.
Daily
• Check the door and door lock:
- Open the door and try starting the machine. The machine MUST NOT START.
- Close the door, start the machine and try opening the door
It MUST NOT BE POSSIBLE TO OPEN THE DOOR WHILE THE MACHINE IS
OPERATING!
- Check that the door does not leak.
- Clean the door seal, removing any detergent and lint.
• Check that there are no indications of leaks behind or around the machine.
• Clean out any residue remaining in the detergent dispenser.
• Inspect liquid chemical tubing and connections for leaks. Repair as necessary.
Every third month (refer this service to qualified personnel)
May only be carried out by authorized personnel.
• Check that the door does not leak.
• Check the drain pump strainer and remove any accumulated lint and debris.
• Inspect the interior of the machine (during an actual wash cycle to ensure that no
leaks are noticed) by:
- Turning of the main power switch of the machine.
- Remove the top panel.
- Start a wash program.
- KEEP CLEAR OF MOVING PARTS WHILE MACHINE IS OPERATING!!
- Inspect all internal hoses, seals and gaskets for signs of leakage.
Repair as necessary.
- Check that water inlet screens are clean of debris. Dirty screens
result in longer fill times, reducing productivity.
- Inspect the drive belt. Adjust the tension or replace as necessary.
- Check that there are no signs of leakage on the floor beneath the
machine. Locate and repair any leak.
Contact your local dealer, or Laundrylux Technical Support at 516-371-0700 if you
have questions regarding installation, operation, or maintenance of your machine.

Preventive maintenance

using reasonable force.
7:1

Publicité

Chapitres

loading

Ce manuel est également adapté pour:

Crossover whwf09810m/nmCrossover ehwf09810m/nm