Publicité
Les langues disponibles
Les langues disponibles
Installation
For safety,two people should install this product.
Leave the machine on the transport pallet until it can be placed in the final, prepared
position.
First remove all the packing materials. Upon opening of the package, water drops may
be seen on the plastic bag and the drum. This is a normal phenomenon resulting from
water tests in the factory.
NOTE: 1. A bottom cover plate is wrapped in the top of the packing material.
2. A coin meter housing is wrapped in the base. Tilt the machine to the left to remove it from
the packing.
3. Be careful while handling the bottom cover and coin box.
4. Remove all anti-scratch film from the washer.
Install the bottom cover plate
1. Lay the package carton on the ground.
Fig.
2. Lay the washer slowly down on its back on the package carton.
1
3. Install the bottom cover on the bottom of the machine using the 8 screws provided
in the accessories bag.
4. Lift the washer to the upright position.
1
Installation
Back Side
Package Carton
2:1
Publicité
Chapitres
