XYZ Printing da Vinci Jr. WiFi Pro Manuel De L'utilisateur page 6

Filament Spool Ring Installation
Note: Please refer to this step if the axle ring is not installed on the spool.
1
Loosen the spool ring mounting
screw from the used filament spool
with a screwdriver, and remove the
spool ring.
Filament Installation
1
Place the assembled filament spool (with the spool
axle rings) on the filament holder on the left side of the
printer.
Caution: Pay attention to the direction the
filament is being pulled out and ensure that the
filament spool axle is rotating smoothly.
Note : Before pushing the filament into the guide
hole, please cut the tip of the filament off at a 45° .
Accessories Installation
HD23FJPW1A7
2
Remove the genuine filament and chip,
and then install the sensor chip. Please
note the direction of the mounting hole on
the chip to attach the chip correctly.
Note: If you are not too sure where the feed module tube
port is, you may open the casing of the machine to see the
indication label.
Click "LOAD FILAMENT" , pull out a section of the filament
2
and insert it into the feed port. Push the filament all the way
to the top so that the front end of the filament is completely
inserted into the feed module. (Please refer to the "LOAD
FILAMENT" sections in the "UTILITIES" chapter)
da Vinci
Jr. WiFi Pro
Insert the spool ring from
3
both sides of the new filament
spool. Tighten the spool ring
with a screwdriver to finish the
installation process.
P 6