XYZ Printing da Vinci Jr. WiFi Pro Manuel De L'utilisateur page 12

Open Filament
1
If you're using third party filaments,
please secure the filament using
the holder.
Load the filament function of the printer function. When the panel displays:
4
"USE XYZPRINTING SPOOL? ", select "NO "> "APPLY SETTING " (and enter temperature settings).
UTILITIES
CHANGE SPOOL
HOME AXES
JOG MODE
Adjust the nozzle temperature according to the
5
supplier's recommendations.
Use the left 【＜】 and right 【＞】 buttons to select
the digits. Use the up 【
buttons to increase or lower the number.
NOZZLE
[ < ] [ > ] , OR [ OK ]
The recommended printing temperature range is 190
7
to 240 C. The screen would display a temperature
range reminder if the temperature settings exceed this
recommended range.
INVALID VALUE
MIN 190 C
MAX 240 C
[ OK ] TO RETURN
REMARK
* Hang the spool on the filament spool holder prepared by yourself, we recommend use the support bracket to avoid
collapsing when printing.
* Print quality cannot be guaranteed if filaments from other brands are used instead.
* The warranty does not cover stuck filaments, product failure, damage or defects resulting from the use of other brand's fila-
ment or 3rd party slicing software.
HD23FJPW1A7
Load the filament from the back
2
of the printer.
CHANGE SPOOL
LOAD FILAMENT
UNLOAD FILAMENT
】 and down 【
】
2 [ 1 ] 0 C
OPEN FILAMENT
In the printer, insert the filament into the
3
feed port. Open the release arm so that
the front tip of the filament can be
properly inserted into the feed module.
USE XYZPRINTING
SPOOL?
YES
NO
Once temperature settings have been completed,
6
press "OK" to complete the settings.
NOZZLE 2 [ 1 ] 0 C
[ < ] [ > ] , OR [ OK ]
8 The user may go to SETTING
>USER FILAMENT
>NOZZLE to set the nozzle temperature.
USER FILAMENT
NOZZLE 210 C
UNLOAD 190 C
da Vinci
Jr. WiFi Pro
USER FILAMENT
APPLY SETTING
--------------------------
NOZZLE 200 C
NOZZLE 2 [ 1 ] 0 C
[ < ] , [ > ]
[ OK ]
TO CONTINUE
P 12