Accessories Installation - XYZ Printing da Vinci Jr. WiFi Pro Manuel De L'utilisateur

Guide Tube Installation
1
Please push the tube remover into the extruder
module port then ensure that the guide tube has
been tightly inserted into the extruder module port.
Place the extruder module that the fitting pin is
3
secured the proper location. Then, insert the black
ribbon connector to complete the installation.
How to Remove the Guide Tube
1
Use two fingers press
the Feeder on the Feed
module.

Accessories Installation

HD23FJPW1A7
2 Pull out the guide tube.
2
Put a guide tube though the guide tube movement area
and then insert it into the extruder module. To finish the
installation, insert the guide tube downward firmly.
B
Guide tube
A
Tube remover
Note:
Please insert the guide tube (B)
which assist to the guide tube installation and remove.
Please keep the tube remover on the guide tube after
guide installation.
3
Please gently press the tube remover, pull the guide
tube upwards to remove the guide tube.
da Vinci
Jr. WiFi Pro
B
A
into the tube remover (A)
P 5