Honeywell Home HE240 Guide D'installation Et Manuel Du Propriétaire page 17

Clean the drain fitting, if
9.
necessary.
Bend the drain hose to
10.
loosen any mineral deposits.
Flush the drain hose with
11.
pressurized water (a running
tap) to clean the hose.
Reattach the drain hose to
12.
the drain fitting.
Slide a new humidifier pad
13.
back into the frame.
Snap the water nozzle back
14.
on the tray.
Reattach the tray to the
15.
frame.
Place the humidifier pad
16.
assembly in the humidifier
housing and press until the
assembly is completely
seated. Be careful not to
pinch or kink the water feed
tube.
Replace the humidifier cover.
17.
Verify the humidifier
18.
operation by following the
steps in the Checking Your
Humidifier for Correct
Operation section.
End of Humidification Season
• Clean the humidifier and shut it off at the end of the heating season.
• Turn the water off at the saddle valve by turning the handle to the right (clockwise)
until the water stops flowing and/or there is resistance.
• Unplug the humidifier at the wall outlet
• Turn the damper blade to the "summer" position.
IMPORTANT
Be sure the humidifier power is off.
Replacement Humidifier Pads
It is recommended to replace the humidifier pad on an annual basis. However, if
your home has hard water, the pad may need to be replaced more frequently
because of the buildup of minerals diminishing its ability to operate normally. If
there is access to a water softener, it is recommended to use softened water.
PerfectFLO™ WATER
DISTRIBUTION TRAY
WATER FEED NOZZLE
HUMIDIFIER PAD ASSEMBLY
HUMIDIFIER HOUSING
WATER FEED TUBE
SIDEWALL
COVER
Table 3. Replacement pad part numbers.
Humidifier
Model
HE240
HE280
HE240, HE280 HUMIDIFIER AND INSTALLATION KIT
Fig. 18. Cleaning your humidifier.
Replacement
Pad
HC22P
HC26P
17
BYPASS
SIDEWALL
M33328A
69-2686EF—03