Use / Operators; Intended Use; Improper Use; Reasonably Foreseeable Improper Use - RK Rose+Krieger DuoLine S Notice D'assemblage

4.1 Intended Use

The linear unit must be used exclusively for a linear process and positioning of workpieces, units,
measuring devices or for other comparable setting tasks in industrial plants.
The linear unit should not be used in areas where there is a risk of explosion or in direct contact
with foodstuffs, pharmaceutical or cosmetic products.
Catalogue information, the contents of these assembly instructions and conditions laid down in
the order are to be taken into account.
The load information given in these assembly instructions shows maximum values which must not
be exceeded.

4.2 Improper use

"Improper use" means that the information given in section 4.1 Intended use is not being
observed.
In the event of improper use, incorrect operation and if this linear unit is used, installed or
handled by untrained personnel, this linear unit may pose risks for the personnel.
If the linear unit is used improperly, then RK Rose+Krieger GmbH ceases to be liable and the
general operating licence of this linear unit will be void.

4.2.1 Reasonably foreseeable improper use

•
Use in an environment where these is a risk of explosion (if used in atmospheres with an
explosion risk, sparks can lead to deflagrations, fire or explosions)
•
Use of the linear unit with permitted forces / torques exceeded
•
Inadequate securing of the linear unit
•
Inadequate securing of the loads to be moved
•
Loads exceeding the specified limits
•
Use in the food processing industry with direct contact with unpacked foods
•
Use outdoors
•
Use outside the ambient temperature range of 0° C to +60° C
•
Operation at ambient temperatures below the dew point
•
Operation in surroundings beyond a relative humidity of 0 - 85%
•
Use outside the specified IP protection class
•
Use in a heavily contaminated environment
•
Use in extremely dusty atmospheres
•
Use in an atmosphere containing solvents
•
Moving of animals or persons
•
Use in liquids

4.3 Who may use, install and operate this linear unit

Persons who have read and understood the assembly instructions completely may use, install and
operate this linear unit. The responsibilities for handling this linear unit must be clearly laid down
and observed.

4. Use / Operators

4. Use / Operators 4. Use / Operators
53 53 53