CAPITAL SPORTS Helix Star UP Mode D'emploi page 42

EN
2
As shown in the figure, the main frame (1) is padded with packing material (A) and the
screws (33+34), which are pre-attached to the connectors of the left and right front
foot tubes and the upper screw (21) of the main frame (1), are first placed aside for
assembly.
Insert the right foot tube connector (3) into the corresponding square connector on the
main frame (1) and secure with three M8*20 octagonal screws (33) and eight elastic
gaskets (34). The other side is assembled in the same way. Remove the packing material
(A) under the main frame (1). Cover the front cover (40) on the square tube at the front
of the main frame mounting assembly (1). Secure with two 4.2*19 crosshead screws
(21).
42