Operation; Manual Controls - Dimplex DF3033ST Manuel Du Propriétaire

Operation

Figure 4
C
WARNING: This electric
firebox must be properly installed
before it is used.

Manual Controls

The manual controls for the
fireplace are located in the upper
right hand corner (Figure 4).
A. On/Off Switch
Supplies power to the 3-Position
Switch.
B. 3-Position Switch
Remote (left position): The unit
is operated with the remote
control.
Flame (center position): The
flame effect is turned on.
Flame & Heat (right position):
The flame effect and heater
are turned on simultaneously.
When the manual control is
in the Flame & Heat position
the heater does not run on
10
B A
the remote operated thermo-
stat.
!
NOTE: When the 3-posi-
tion switch is in the Flame or
Flame & Heat positions, the
fireplace unit will not operate
with the remote control.
C. Initialization Button
Used to synchronize the remote
control with the fireplace.
!
NOTE: The heater on your
fireplace may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts and will
not occur again.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset. The
temperature cutoff switch can be
reset by unplugging the unit, wait-
ing five (5) minutes and plugging
the unit back in.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dim-
plex North America Limited at
1-888-346-7539 for technical
www.dimplex.com