Lamp Unit Replacement - Toshiba 44NHM84 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Lamp Unit Replacement

• To obtain a replacement lamp unit:
• In the U.S.:
In warranty
Out of
warranty
• In Canada, contact a Toshiba parts distributor by directing your web browser to www.toshiba.ca Click
"Home Entertainment," and then click "Support."
Use the replacement lamp unit model listed below only. Using any other lamp may cause damage to the TV
and/or lamp. Model name is TBL4-LMP.
You must replace the lamp when:
• The image gets darker or starts to deteriorate.
• Follow the instructions to replace the lamp, as shown below.
1. Turn off the TV and unplug the power cable.
2. STOP! Allow the lamp to cool for at least one (1) hour before replacing it.
3. Remove the 2 retaining screws on the lamp cover with a Phillips type screwdriver. Remove the lamp door
completely from the TV.
lamp unit door completely. Failure to follow this WARNING may result in death or seri-
ous injury.
4. Remove the two retaining screws on the lamp case with using Phillips type screwdriver.
5. Lift up the fixed wire handle of the lamp.
P A G E 5 0
Web
www.tacp.toshiba.com/service
www.ceaccessories.toshiba.com
CAUTION:
Always replace with same type lamp unit: Model No.
[TBL4-LMP]
CAUTION: HOT SURFACE!
The temperature of the lamp immediately after use exceeds
392°F (200°C). Touching the lamp before it has cooled
will result in severe burns. ALLOW THE LAMP TO COOL FOR
AT LEAST ONE (1) HOUR BEFORE REPLACING IT.
WARNING: RISK OFF ELECTRIC SHOCK!
The lamp unit door is provided with an interlock to reduce the
risk of electric shock and excessive ultraviolet radiation. Never
defeat its purpose or attempt to service without removing the
Contact
.
Call toll-free 1-800-631-3811
Consult your consumer elec-
tronics dealer for availabili-
ty.

Publicité

Chapitres

Table des Matières
loading

Table des Matières