Maintenance; Troubleshooting; 10 Spare Parts; Replacing Batteries - resideo Braukmann VE300S Instructions D'installation

Hardness
(see also 5.1 Measuring the water hardness)
Set the water hardness
Display switches between °dh, °fh and ppm
For water hardnesses > 26 °dh/46.3 °fh/463 ppm, the
max. water hardness should be confirmed
Cartridge
non rinsing mode without cartridge
P300-LES Setting of installed cartridge P300-LES
P300-LESxL Setting of installed cartridge P300-LESxL
P300-S Setting of installed cartridge P300-S
P300-L Setting of installed cartridge P300-L
During rinsing mode without cartridge (none), connect
rinsing/blindplug, art. no. BS300-1/2A.
Other functions of the control keys
• Press and hold ON/INFO and Hardness control keys
at the same time for 3 s
– Information about total litres is reset to 0
• Press and hold Hardness and Cartridge control keys
at the same time for 3 s
– Information about cartridge changes is confirmed
• Press and hold ON/INFO and Cartridge control keys
at the same time for 3 s
– Valve ON/OFF
7

Maintenance

In order to comply with EN 806-5, water fixtures must
be inspected and serviced on an annual basis.
As all maintenance work must be carried out by an
installation company, it is recommended that a
servicing contract should be taken out.
In accordance with EN 806-5, the following measures must
be taken:
9

Troubleshooting

Problem
Water is not of the desired hardness

10 Spare Parts

For Spare Parts visit homecomfort.resideo.com/europe
MU1H-1564GE23 R0420
GB

7.1 Replacing batteries

1.
2.
3.
7.2 Replacing softening or
When the fill volume of the heating system exceeds the stated
capacity, the cartridge must be replaced.
For softening:
For complete demineralisation:
1.
2.
3.
4.
8
Observe the local requirements regarding correct waste
recycling/disposal!
Cause
Hardness incorrectly set
Cartridge capacity all used up
Dirt particles have entered the mixing
openings
11
For Accessories visit homecomfort.resideo.com/europe
5
The batteries have a service life of around 5 years.
Take electronics module out of refilling unit
Replace batteries (alkaline AA 1.5 V)
Reattach electronics module
demineralisation cartridge
Service LED
Flashing yellow
cartridge capacity below 10 %
flashing red +
Cartridge capacity all used up
tone
Cartridge in use for more than 5
years
For safety reasons, the softening cartridge must be
replaced 12 months after it is first used at the latest.
For safety reasons, the complete demineralisation
cartridge must be replaced 12 months after it is first
used at the latest.
Open bleeder valve and relieve pressure in system
• Place bucket under system
Unscrew cartridge from refilling unit
Screw in new cartridge until finger-tight
Press Hardness and Cartridge control keys at the
same time for 3 s
• Information about cartridge changes is confirmed
If the new cartridge differs from the old one, e.g.
different sizes (L/XL), the new cartridge must be
selected and confirmed by selecting it with the
Cartridge button.

Disposal

Remedy
Adjust hardness range
Replace cartridge insert
Rinse cartridge

Accessories