Table des Matières
Publicité
1. Installation
It is necessary during installation to
observe codes of good practice, to comply
with local requirements and to follow the
installation instructions. The installation
location should be protected against frost
and be easily accessible.
1.1 Assembly (Fig. 1)
1. Thoroughly flush pipework.
2. Close valves 1 and 2 .
3. Install the Y strainer 3
Where possible, fit in horizontal
●
pipework.
Seal plug 6 pointing downwards
●
4. Slowly open valves
2. Cleaning
Regular cleaning of the strainer is
recommended.
2.1 Drinking water systems
In drinking water systems it is recommended
that the strainer be cleaned at interval of
more than six months.
2.2 Other installations
The time interval between cleaning depends
on the degree of contamination in the
system. Where exessive dirt is present, the
blanking plug 6 can be replaced by a valve
to enable bulk deposits to be cleaned out.
If this is not done, strainer blockage
●
can occur, resulting in pressure loss
and reducing water flow rate
The strainers are of stainless steel.
●
Red deposits from the pipework do
not affect the function or filtering
efficiency.
3. Maintenance
1. Close valves 1 and
4
2. Open seal plug
3. Remove strainer 5
4. Clean strainer or, if necessary, replace.
5. Reassemble in the reverse sequence.
6. Open valves
1
and
1
and
2
.
(Fig. 3)
2
.
.
2
.
GB
4. Range of application
For FY69P
Connection
sizes:
DN 15 - DN 200
Medium:
Water, oil, compressed air,
steam and other non-
aggressive mediums
Operating
pressure:
Maximum 16.0 bar (for water,
oil or compressed air)
Maximum 6.0 bar (for steam)
Operating
temperature:
Maximum 150 °C
Installation
position:
In horizontal or vertical
pipework with seal plug
pointing downwards
For FY71P
Connection
sizes:
DN 65 - DN 150
Medium:
Water, oil and compressed
air up to 40 bar, for steam
according to DIN 2401
pressure rating PN 40
Operating according to DIN 2401
pressure: pressure rating PN 40
Operating
temperature according to DIN 2401
pressure rating PN 40
Installation
In horizontal or
position:
vertical pipework with
seal plug pointing
downwards.
5. Safety guidelines
1. Use the appliance
In good condition
●
According to regulations
●
With due regard to safety.
●
2. Follow installation instructions
3. Immediately rectify any malfunctions
which may influence safety.
4. The strainers are exclusively for use in
applications detailed in these installation
instructions. Any variation from this or
other use will not comply with requirements.
4
Publicité
Table des Matières
