Imetec M5001 Instructions Pour L'emploi page 9

plastic bag out of the reach of children - risk of suffocation!
• Before connecting the appliance, make sure that the
voltage data (9) specified on the identification technical
data correspond to those of the available mains voltage.
The identification technical data are found on the appliance
(9).
• This appliance must be used only for the purpose for
which it was designed, namely as a hair straightener for
home use. Any other use is considered not compliant and
therefore dangerous.
• When the appliance is used in a bathroom, unplug it after
use since the proximity of water presents a hazard even
when the appliance is switched off.
• For additional protection, the installation of a residual
current device (RCD) having a rated residual operating
current not exceeding 30 mA (ideal 10 mA) is advisable
in the electrical circuit supplying the bathroom. Ask your
installer for advice.
ATTENTION: Do not use this appliance near
bathtubs, showers, basins or other vessels
containing water. Never place the appliance in
water.
• This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children must not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
DO NOT use the appliance with wet hands, damp feet
or barefoot.
DO NOT pull the power cable or the appliance itself to
remove the plug from the socket.
DO NOT expose the appliance to humidity or weather
conditions (rain, sun, etc.).
• Always disconnect the appliance from the mains supply
before cleaning or performing maintenance and when the
appliance is not in use.
• If the appliance is faulty or malfunctions, switch it off and
do not tamper with it. Any repairs must only be carried out
by an authorised technical service centre.
• If the power cable is damaged it must be replaced by an
authorised technical service centre, so as to prevent all risks.
7