Fellowes Galaxy-e Wire Mode D'emploi page 5

STEPS TO BIND – MULTIPLE DOCUMENTS
1
1. Test close selected wire comb.
Set closure lock as required. Check
wire seam closure is complete.
5
5. Lift the wire closing lever. The
jaws will close at the pre-selected
stop position.
FINISHING THE BINDING
1
1. Check the closed seam. If
the seam is not closed correctly,
the document can be placed
into the jaws and closed again.
2
2. Starting with the rear cover.
Load punched sheets directly onto
the hanging open wire comb.
2
2. To hide the seam, turn the
rear cover backwards. The front
cover is now visible. The seam is
hidden inside the document.
3
3. Punch and hang the front
cover. Punch and hang the
remaining sheets.
3
3. Check wire seam closure is
complete. Loose binding allows
sheet loss. Good closure retains
all sheets.
4
4. Lift the wire comb upwards off
the hooks. Carefully place into the
open wire closing jaws. Ensure the
wire comb is open and touching the
bottom of the mechanism.
5