Precautions For Use - Panasonic TH-49LFV8U Manuel De Base

Clean the power cable regularly to prevent it
becoming dusty.
If dust built up on the power cord plug, the resultant
•
humidity can damage the insulation, which could
result in fire. Pull the power cord plug out from the
wall outlet and wipe the mains lead with a dry cloth.
Do not step on, or hang from the display.
They might tip over, or might be broken and it may
•
result in injury. Pay special attention to the children.
Do not reverse the polarity (+ and -) of the battery
when inserting.
Mishandling the battery may cause its explosion
•
or leakage, resulting in fire, injury or damage to
surrounding properties.
Insert the battery correctly as instructed. (see page
•
10)
Do not use batteries with the outer cover peeling
away or removed.
(The outer cover is attached to the battery for safety.
It must not be removed. Doing so may cause short
circuits.)
Mishandling the batteries may cause the batteries
•
to short circuit, resulting in fire, injury or damage to
surrounding properties.
Remove the batteries from the remote control
transmitter when not using for a long period of time.
The battery may leak, heat, ignite or burst, resulting in
•
fire or damage to surrounding properties.
Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such
•
as sunshine, fire or the like.
Do not turn the Display upside down.
Do not position the unit with its liquid crystal panel
facing upright.

Precautions for use

Unpacking
This product is packed in a carton, together with the
•
standard accessories.
Any other optional accessories will be packed
•
separately.
Due to the size and weight of this display it is
•
recommended for two people to move it.
After opening the carton, ensure that the contents are
•
complete and in good condition.
Cautions when installing
Do not set up the Display outdoors.
The Display is designed for indoor use.
•
Install this unit at a location which can support the
weight of the unit.
Use the installation bracket that conforms to VESA
•
standards
Environmental temperature to use this unit
When using the unit where it is below 1 400 m (4 593
•
ft) above sea level: 0 °C to 40 °C (32 °F to 104 °F)
When using the unit at high altitudes (1 400 m (4 593
•
ft) and higher and below 2 800 m (9 186 ft) above sea
level): 0 °C to 35 °C (32 °F to 95 °F)
Do not install the unit where it is 2 800 m (9 186 ft)
and higher above sea level.
Failure to do so may shorten the life of the internal
•
parts and result in malfunctions.
We are not responsible for any product damage, etc.
caused by failures in the installation environment
even during the warranty period.
Do not place the display where it may be affected by
salt or corrosive gas.
Failure to do so may shorten the life of the internal
•
parts and result in malfunctions due to corrosion.
Required space for ventilation
For the outermost periphery of the display, leave a
•
space of 10 cm (3.94") or more at the top, bottom, left
and right.
At the rear, leave a space of 5 cm (1.97") or more.
About the screws used when using a wall hanging
bracket that conforms to VESA standards
Inch Screw pitch for
model installation
49/55 400 mm × 400 mm
Installing multiple displays
•
When installing multiple displays, the LCDs may
dilate due to temperature change inside the main unit,
resulting in malfunction.
Depth of
Screw
screw
(quantity)
hole
10 mm M6 (4)
English
7