Réglage Des Points De Consigne; Setpoint Adjustment - YOKOGAWA EXA DO402G Manuel D'instructions

5-4 Réglage des paramètres
5-1-3. Réglage des points de consigne

5.4 Setpoint Adjustment

YES NO
YOKOGAWA
MODE
YES NO
NO
NO
NO
NO
NO
YES
NO
Setpoint analogue
control output (mA2)
when enabled in code 31
IM 12J6B3-F-E
MODE
MEASURE
SETPOINTS
RANGE
SET HOLD
WASH
SERVICE
CONTACTS
MODE
S1
S2
WASH/S3
ENT
FAIL/S4
MARKINGS
WITHIN
ENCLOSURE
AIR.CAL
YES
NO
Setpoint 3 and 4
when enabled in
service codes
42 and 43
Note: To enable adjustment of setpoints in
maintenance mode, Service Code 51
must be set to "ON".
Setpoints available will depend on their
configuration in the Service Code.
For adjustments,
follow procedures
YES
as in section 5-5-1.
YES
NO
YES
NO
For adjustments,
follow procedures
YES
as in section 5-5-1.
YES
NO
12J6B2-13