Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. ID SET
Press the Up button on the remote control for 5 seconds.
• Until pairing is complete, the Multicolor LED changes as Red → Green → Blue in turn.
Remote Control Button
CAUTION
• If your Soundbar was playing music when it connects to the SWA-9100S, you may hear some
stuttering from the woofer as the connection finalizes.
4. Check if the LINK LED is solid blue (connection complete).
STANDBY
STANDBY
LINK
5. If the SWA-9100S is not connected, repeat the procedure from Step 2 through 4.
5 Sec
LINK
Blue is On
Red
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Receiver Module.
ENG - 20
LED Indicator
→
→
Green
Blue Blinks
Pairing
Cyan Blinks X3
Connection is complete
Publicité
Chapitres
Table des Matières
Dépannage
