Overhead Rigging - JB Systems Party Derby Mode D'emploi

ENGLISH

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12 times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
HOW TO SET UP AND CONTROL THE UNIT
You can operate the unit in several ways:
1) FULL AUTOMATIC STANDALONE MODE:
The effect automatically runs a random show of the preprogrammed sequences. Select this mode when
only 1 PARTY DERBY unit is used (standalone) or when the unit is placed as the first (master) unit in a
chain with several PARTY DERBY.
 Press the [MENU] button until the display shows [Aut].
 Press the [ENTER] button to confirm your choice.
 Now you can use the UP or DOWN buttons to select the desired effect group:
o [AutP] Automatic RGB projector show.
 Press [ENTER] to select this mode.
 Use the [UP] and [DOWN] buttons to select the desired show speed from [S.01] slow to [S.99]
fast
 Press [ENTER] to confirm your setting
o [AutF] Automatic white flash show.
 Press [ENTER] to select this mode.
 Use the [UP] and [DOWN] buttons to select the desired show speed from [S.01] slow to [S.99]
fast
 Press [ENTER] to confirm your setting
o [AutM] Automatic mixed effects show.
 Press [ENTER] to select this mode.
 Use the [UP] and [DOWN] buttons to select the desired show speed from [S.01] slow to [S.99]
fast
 Press [ENTER] to confirm your setting
You can connect several PARTY DERBY together: just put the first unit of the chain in one of the
automatic effect modes and all other units in "Slave mode" (display shows "SLA") to make them all work in
perfect sync!
2) SOUND CONTROLLED STANDALONE MODE:
The PARTY DERBY runs a preprogrammed sequence to the rhythm of the music. Select this mode when
only 1 PARTY DERBY is used (standalone) or when the PARTY DERBY is placed as the first (master) unit
in a chain with several units.
 Press the [MENU] button until the display shows [Sou].
 Press the [ENTER] button to confirm your choice.
JB SYSTEMS
®
4/49
USER MANUAL
PARTY DERBY