Elmo Teacher's Tool TT-02s Mode D'emploi page 21

Specifications of the analog RGB input terminal of this product
Signal allocation
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
DSUB 15P shrink terminal (Female)
Pin assignment
Pin No. Name
1 Video signal (Red)
2 Video signal (Green)
3 Video signal (Blue)
4 N.C
5 GND
(3) Connecting to the unit with composite video input terminal equipped
Connect the video cable with RCA pin plug to the [VIDEO OUT] terminal on the rear panel.
(4) Connecting to the PC with a USB cable
Connect a USB cable to the [USB] terminal on the rear panel.
Note
• The USB cable compliant with USB2.0 is recommended.
• If you plug into a USB connector with power on, PC may not recognize this product.
• Depending on the USB environment of PC or the USB2.0 compliant cable is
recommended. Peripheral units, the image transfer may be disturbed.
• This does not guarantee operations in any environment.
(5) Connecting the AC adapter
Connect the DC plug of the supplied AC adapter to the [DC IN 12V] terminal on the rear
panel before inserting the AC adapter in an outlet.
Note
• As for switching-over of the image output, refer to "OUTPUT (DIP switch)" on page 12.
• To protect the unit and peripheral devices, unplug the power plug and the AC adapter,
turn OFF power switches of all other devices before connecting video cable.
• Hold the plug of cable to plug/unplug the power plug/the AC adapter or video cable.
English
Video signal : Analog 0.7V(p-p) with 75Ω terminated
Horizontal synchronized signal : TTL level (Positive/negative polarity)
Vertical synchronized signal : TTL level (Positive/negative polarity)
Pin No. Name
6 GND (Red)
7 GND (Green)
8 GND (Blue)
9 N.C
10 GND
Pin No. Name
11 GND
12 N.C
13 Horizontal
sync. signal
14 Vertical
sync. signal
15 N.C
21