Assembling Your Telescope; The Tripod; The Computerized Mount - Celestron LCM Serie Mode D'emploi

ASSEMBLING YOUR TELESCOPE

THE TRIPOD

The LCM tripod comes fully assembled, so setting it up is easy To
setup the tripod:
1 . Remove the tripod from the box
2 . Loosen the clamps on the bottom of each leg by flipping the
lever outward Extend the inner section of the leg to the desired
length Tighten the leg clamp by flipping the lever inward to
secure the legs
3 . Stand the tripod upright and pull the tripod legs apart until the
center brace snaps into place
4 . Place the accessory tray on top of the center brace
line up the keyed hole in the center Rotate the tray until
the tabs at the three points of the tray snap into the
locking clips on each arm of the tripod's center brace
5 . Attach the hand control holder by positioning the holder with
the square plastic tab facing up and push against the tripod leg
until it snaps in to place

THE COMPUTERIZED MOUNT

To attach the computerized mount to the tripod:
1 . Place the motorized base on top of the tripod making sure that
the three round feet rest on the round flat pads on the inside of
the tripod head
2 . Thread the mounting screw located under the tripod head into
the hole at the bottom of the motorized base and hand tighten
to secure the mount in place
Now that the base is attached to the tripod, it is a good idea to use
the included bubble level to more accurately level the telescope:
3 . Place the bubble level on the top of the motorized base
4 . Adjust the tripod legs until the bubble level shows the base to
be leveled
8 I ENGLISH