Operating Instructions - BE P1615EN Mode D'emploi

Attach garden hose to the garden
hose adapter (G).
Note: Flush out garden hose before
connecting to garden hose adapter.

OPERATING INSTRUCTIONS

• Turn on water supply at the
faucet to completely open
• Make sure the "ON/OFF" switch
is in the "OFF" position. The
power switch has international
symbols for 'on' and 'off': On (|)
Off (O).
• Unwind the power cord
completely and plug the GFCI
into a grounded 120 volt outlet.
• Release safety push trigger lock
up and back into trigger. While
pointing the spray gun in a safe
direction, squeeze the trigger
on the spray gun until there is a
steady stream of water, letting
the water and air out of the
hose. Push trigger lock back
down to lock back into place.
10
You have now completed assembly
and are ready to begin using your
electric power washer. Read and
observe all safety instructions.
0 0
I I
• Turn the power switch to the "ON" (|)
position. The unit will turn on for 1 - 2
seconds and shut off. This is a normal
function of the auto start feature.
Squeeze the spray gun trigger to
begin pressure washing.
• Begin power washing by squeezing
the trigger on the spray gun all the
way into the handle.
• Release the spray gun trigger to stop
the power washer
• Allow the motor to come to a
complete stop before squeezing the
trigger again.
• Squeezing rapidly will cause the auto
start feature to miss an on/off cycle
that may prevent it from turning on
while squeezing trigger after rapid
squeezing. Use slow deliberate
trigger pulls to avoid such symptoms.
• Always test a small area to avoid
chance of
damaging the
surface.
IN position
1
IN position
2
2
High Pressure Setting
Fan Spray Pencil Stream
OUT position
1
OUT position
2
LOW Pressure Setting
Pencil Stream
Using High/Low Nozzle
• High pressure spray is used for
cleaning and low pressure spray
activates the detergent function.
• The adjustable spray nozzle had has
two (2) positions:
– IN position for high pressure spray.
Twist the nozzle counterclockwise
until it stops and gap is closed.
– OUT position for low pressure
spray for detergent function. Twist
the nozzle clockwise until it stops
and gap is open.
• When using the high pressure setting,
twist the nozzle head clockwise
or counterclockwise to achieve
the stream desired.
• When using the low pressure
setting twist the nozzle head
clockwise to open the fan blades
all the way.
IMPORTANT: When applying
detergent using low pressure
spray, the variable spray head
must be set for the "Pencil
Stream". This is when the metal
blades in front of the nozzle are
wide open so the detergent spray
is not constricted.
• When using the detergent, fill
it with a properly formulated
detergent or cleaner with water
ratio according to instructions on
the container.
• DO NOT use thick gel-like
detergents, as they will clog the
power washer and can cause
damage.
11