Operating Instructions - BE Power Equipment P1715EN Manuel D'utilisation

OPERATING INSTRUCTIONS

• Make sure the "ON/OFF" switch is in the "OFF"
position. The power switch has international
symbols for 'on' and 'off': On (|) Off (O).
• Unwind the power cord completely and plug the
GFCI (For US unit only) into a grounded 120 volt
outlet.
• Turn on water supply at the faucet to completely
open.
• Release safety push trigger lock up and back into
trigger. While pointing the spray gun in a safe
direction, squeeze the trigger on the spray gun
until there is a steady stream of water, letting the
water and air out of the hose. Push trigger lock
OFF/0
ON/I
bepowerequipment.com
OFF/0
ON/I
back down to lock back into place.
• Turn the power switch to the "ON" (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This
is a normal function of the auto start feature.
• Begin power washing by squeezing the trigger on
the spray gun all the way into the handle.
• Release the spray gun trigger to stop the power
washer
• Allow the motor to come to a complete stop before
squeezing the trigger again.
• Squeezing rapidly will cause the auto start feature
to miss an on/off cycle that may prevent it from
turning on while squeezing trigger after rapid
squeezing. Use slow deliberate trigger pulls to
avoid such symptoms.
• Always test a small area to avoid chance of
damaging the surface.
11