BE P1615EN Mode D'emploi page 5

3
A
D
Soft PVC High Pressure Hose
Assembly
Screw Soft PVC high pressure
hose (D) clockwise onto bottom
front of power washer unit (A).
Pull back collar and insert o-ring
post into water outlet far enough
so collar can thread onto outlet
threads until hand tight. If it takes
fewer than six turns you have not
properly tightened the Soft PVC
high pressure hose fitting. It is
easier to position the power washer
in front of you to ensure that the
threads are started correctly. Failure
to properly tighten Soft PVC high
pressure hose will result in the hose
slipping or popping off immediately
upon turning unit on. Do not worry
about damage if this occurs–just
reinstall and take extra care when
screwing on the Soft PVC high
pressure hose fitting.
Note: DO NOT use pliers or locking
pliers to tighten.
8
4
I
D
Connect the other end of Soft
PVC high pressure hose (D) to
spray gun (I) by inserting the
brass metal tip of high pressure
hose into the fitting just ahead
of trigger guard. It will lock into
spray gun with a "click". Confirm
hose is locked into spray gun by
slightly pulling on them. The hose
is now securely attached to spray
gun.
Note: DO NOT press button on
underside of gun when connect-
ing hose to gun.
5
I
D
2
To release hose (D) from spray gun
(I), press button on underside of
gun toward trigger guard. The hose
will slide out from connection.
ASSEMBLY INSTRUCTIONS
6
Lock
I
J
Unlock
I
Locking Spray Gun (before
Lance installation)
To lock the trigger of the spray
gun (I), aim the gun away from
you and push the lock button
from right to left. After doing
so, squeeze or pull the trigger
to make sure it is locked and
will not move. Always leave
lock button in locked position
when not in use. This ensures
the gun is in "safe" mode until
it is ready for use.
7
F H
I
H
High/Low Nozzle Lance
and Turbo Nozzle Lance
Installation
While the spray gun (I) is in
the locked position, insert the high/
low nozzle lance (F) or turbo nozzle
lance (H) into the end of the spray
gun, by inserting and pushing together
turning clockwise simultaneously.
To remove, push together and turn
counterclockwise.
Note: Always push the safety lock
button to lock the trigger when
changing lances to ensure that they do
not accidentally eject with force during
removal.
Note: When using the turbo lance,
make sure the turbo nozzle is screwed
on tight at the end of the lance each
time you use it.
8
A
G
Garden Hose Adapter Installation
Attach collar of garden hose adapter
(G) directly to power washer water
inlet (A). Hand tighten.
9
G
9