Overflow Line Connection; Electrical Connection - Aerus Origins WC400 Manuel D'utilisation

Overflow Line Connection

In the event of a malfunction, the regenerant tank overflow will
direct "overflow" to the drain instead of spilling on the floor. This
fitting should be on the side of the cabinet or regenerant tank,
Figure 12.
To connect the overflow line, locate the connection on side of the
regenerant tank. Insert overflow fitting into tank and tighten with
plastic thumb nut and gasket. Attach length of 1/2-inch (1.3 cm)
I.D. tubing (not supplied) to fitting and run to drain. Do not elevate
overflow line higher than overflow fitting.
Do not tie into drain line of control unit. Overflow line must be a
direct, separate line from overflow fitting to drain, sewer or tub
with an air gap at the drain.
Figure 12
Regenerant Line Opening
Overflow Fitting
Drain Tubing
Secure hose
in place
Air Gap
Drain

Electrical Connection

Note: There are no user serviceable parts in the AC adapter,
motor or the control board.
The Analyzer control operates on a 12-volt alternating current
power supply. This requires use of the supplied AC adapter. AC
adapters are available from your supplier for different applications.
They include:
AC Adapter Input Voltage
Standard
120V 60 Hz
wall-mount
Outdoor rated 120V 60 Hz
120V AC Adapters:
Make sure power source matches the rating printed on the AC
adapter.
Note: The power source should be constant. Be certain the AC
adapter is not on a switched outlet. Power interruptions longer
than eight hours may cause the control to lose the day and time
settings. When power is restored, the control will display four
dashes (- - :- -) indicating that the day and time settings must
be re-entered.
13
Application Part Number
UL listed for
1000811
dry locations
UL listed
for outdoor 1235448
installations