Troubleshooting And Repair - Ardisam Eskimo Ice Fishing Gear HC40Q8 Manuel De L'utilisateur

PROBLEM
Engine will not start
Engine runs rough, floods during
operation
Engine is hard to start
Engine misses or lacks power
Auger turns at idle
Auger turns, but has no power
Auger jumps on ice
Auger cuts slowly
Contact service provider if above remedies fail, or visit our website at www.GetEskimo.com for additional frequently asked questions.
Parts may be obtained from the store where your auger was purchased or by calling Ardisam customer service at the number listed
below. To order from the factory, call, e-mail, or order online at www.GetEskimo.com:
Please include the part numbers, part description, quantity, model number, and serial number.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT

TROUBLESHOOTING AND REPAIR

POSSIBLE CAUSE
1. On/Off valve off
2. Spark plug wire disconnected
3. Out of fuel
4. Spark plug wet, faulty or
improperly gapped
1. Dirty air filter
2. Carburetor out of adjustment
1. Excessive oil in cylinder
2. Fuel too cold
3. Engine too cold
1. Faulty ignition coil
2. Carburetor out of adjustment
1. Idle speed too high
2. Broken clutch spring
1. Carburetor out of adjustment
2. Broken transmission
3. Worn clutch shoes
1. Blades damaged or sharpened
incorrectly
1. Dull blades
2. Damaged point
ORDERING REPAIR PARTS
Eskimo®
A Division of Ardisam, Inc.
1-800-345-6007
E-mail: info@geteskimo.com
Propane Powered Ice Auger
REMEDY/ACTION
1. Switch to ON
2. Connect spark plug wire to spark plug
3. Refuel
4. Clean, replace or gap spark plug
1. Clean or replace air filter
2. Consult authorized service center
1. Remove spark plug and clear oil from plug and
cylinder
2. Replace cylinder with one that has been stored in a
warm location
3. Move engine to a warm location to warm up
1. Take to authorized service center
2. Take to authorized service center
1. Adjust idle speed lower
2. Replace both springs
1. Consult authorized service center
2. Consult authorized service center
3. Replace clutch shoes and springs
1. Replace with new blades
1. Replace with new blades
2. Replace with new point
Operator's Manual
11