Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
If the silicon gasket is damaged, do not use the appliance and
contact our Customer Service department (see the 'WARRANTY'
section).
•
Never use abrasive cleaners or scouring pads to clean any of the
parts.
•
Make sure that the parts are clean and dry.
DO NOT IMMERSE THE HOUSING IN WATER OR ANY OTHER LIQUIDS!
To clean the parts of the lid
•
Check that the steam release knob and the floating valves are in
good working order before each use.
•
After the unit has cooled, remove the lid.
•
Turn the lid upside down and remove the anti-block shield. Simply
pull firmly on the anti-block shield to remove. Check the exhaust
valve (also referred to as floating valve) and clean if necessary.
•
Using a brush, check for and remove any food or foreign particles
that may be lodged in the exhaust valve or floating valve.
•
Replace the anti-block shield on the bottom of the exhaust valve.
Firmly push the anti-block shield to secure it in position.
Any other servicing should be performed by an authorized service
representative!
TROUBLESHOOTING
If you have not added sufficient liquid and you notice that the floating
valve has not risen, but the timer is counting down, perform the
following steps:
•
Stop the pressure cooker by pressing the "Start/Stop" button
•
Turn the steam release knob to the "Release" position, until the
pressure is fully released.
•
Carefully remove the lid and add approximately 1.5 cups of
water/stock or any liquid. Stir food to disperse liquid.
•
Replace the lid and lock into position.
•
Select your desired preset menu and adjust the cooking time if
necessary.
www.KALORIK.com
17
EPCK 44847 - 180330
Publicité
Table des Matières
