Local Air Conditioner Care; Draining The Air Conditioner; Cleaning The Outside; Cleaning The Air Filter - Hisense APC12 3010F Instructions D'installation

Draining the Air Conditioner

C
D
A.Secondary drain plug
B.Secondary drain cover
C.Primary drain plug
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
1. Unplug the air conditioner or disconnect power.
2. Move the air conditioner to a drain location or outside.
NOTE: To avoid spilling water from the bucket, move the air
conditioner slowly and keep it level.
3. Remove the primary drain
4. Drain water completely by
NOTE: If the air conditioner will be stored after use, see

"Storing After Use".

5. Reinstall the drain plug to the primary drain hole.
6. Reinstall the primary drain cover to the drain hole.
7. Reposition the air conditioner.
8. Plug in the air conditioner or reconnect power.

Cleaning the Outside

1. Press ON/OFF to turn off the air conditioner.
2. Unplug the air conditioner or disconnect power.
3. Remove the air filter and clean separately. See "cleaning the
Air Filter ".
4. Wipe the outside of the air conditioner with a soft, damp
cloth.
5. Plug in the air conditioner or reconnect power.
6. Press ON/OFF to start the air conditioner.

LOCAL AIR CONDITIONER CARE

A
B
D.Primary drain cover
cover and plug .
the drain hole .

Cleaning the Air Filter

A
A. Evaporator air intake fliter panel
1. Press ON/OFF to turn off the air conditioner.
2. Open the filter panel door on the back of the air conditioner
and remove.
3. Remove the air filter from the filter panel door.
4. Use a vacuum cleaner to clean the filter. If the filter is very
dirty, wash the filter in warm water with a mild detergent.
NOTE: Do not wash the filter in the dishwasher or use any
chemical cleaners.
5. Air dry the filter completely before replacing to ensure
maximum efficiency.
6. Reattach the air filter to the filter panel door.
7. Reinstall the filter panel door .
8. Press ON/OFF to start the air conditioner.
Storing After Use
1. Drain the water completely. See "draining the Air
Conditioner ".
2. Run the air conditioner set to Fan Only for approximately
12 hours to dry the air conditioner.
3. Unplug the air conditioner.
4. Remove the flexible exhaust hose and store with the air
conditioner in a clean, dry area. See " installation
Instructions ".
5. Remove the window kit and store with the air conditioner in a
clean, dry area. See " Installation Instructions ".
6. Remove the filter and clean. See Cleaning the Air Filter.
7. Clean the outside of the air conditioner. See " Cleaning the
Outside ".
8. Reinstall the filter.
9. Remove the batteries and store the remote control with the
air conditioner in a clean, dry area.
23
door