Hisense APC12 3010F Instructions D'installation page 22

Temperature
Press the UP button to raise the temperature. Press
■
the UP button once to increase the set temperature
by 1°C.
UP
Press the DOWN button to lower the temperature.
■
Press the DOWN button once to decrease the set
temperature by 1°C.
NOTES:
In the Cooling and Heating mode, the temperature can be
■
set between 16 C and 30 C. °
In Fan Only mode,the temperature cannot be set.
■
Sleep mode
SLEEP mode can be set in Cooling, Heating or Dry operation
mode. This function gives you a more comfortable environment
for sleep.
NOTE:
The appliance will stop operation automatically after operating
■
for 8 hours.
■ Fan speed is automatically set at low speed.
In the Cooling mode, if the current room temperature is
■
below 26°C , the temperature will automatically increase
1°C during the first hour after Sleep control is activated,
then remain the same.
If room temperature is 26
not change.
In Heating mode, set temperature will decrease by 3°C
■
at most for 3 hours constantly, then keeps steady.
1. Press MODE to select Cooling, Heating or Dry.
NOTE: Sleep control cannot be selected when Fan Only
or SMART is selected.
2. Press the UP or DOWN button to set the temperature.
3. Press SLEEP. After 5 seconds, the lights on the control panel
display will dim.
DOWN
°
SLEEP
°C or above,set temperature will
NOTE: The temperature and airflow direction may be adjusted
during Sleep control. The fan speed is automatically set to
Low speed. After 5 seconds, the lights on the control panel
display will dim again.
4. To turn off Sleep control, press SLEEP, MODE, FAN,
ON/OFF,SUPER or wait 8 hours for Sleep control to turn off
automatically.
NOTE: The air conditioner will return to previous settings after
Sleep control is turned off.
I FEEL
The temperature sensor built in remote controller is activated.
It can sense its surrounding temperature, and transmit the signal
back the unit. the unit can adjust the temperature so as to provide
maximum comfort.
NOTE:
Used to set IFEEL mode operation. Press it once, the IFEEL
function will be started. Press it again, the IFEEL function
will be shut off.If the IFEEL function can't be shut off, please
try to press this button about 5 seconds.
Advice to put the remote controller in the place where the
indoor unit receive signal easily.
Advice to cancel the IFEEL mode so as to save energy
when stopping the air conditioner.
DIMMER
Press the DIMMER button to turn off the light and the display in the
unit.
NOTE:
When the light is off, receive signal will turn on the light again.
■
21
IFEEL
DIMMER