Final Photo; Use Timer; Manual Release; Adjust Camera Settings - Rollei 28009 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

5.4 Final photo

If the interval timer has completed the selected
number of shots, the shooting will end automatically.
To finish the shooting task before all the photos have
been finished, press TIMER START/STOP button (5).
Shutter speed is selected by camera
Using the camera to set the shutter speed, please
adjust the setting according to the table below.
Camera
Exposure mode
Shutter mode
Focusing mode
Photo mode
Timer shut-
Exposure time
ter release
Interval time
remote
• If possible, select release priority.
• To ensure that the camera has sufficient time to
focus, when using AF, select an interval of at least
2 seconds longer than the shutter speed of the
camera. When using the long exposure NR function
(for some digital cameras only), select at least the
camera shutter interval two times longer.
M (manual) or S
(shutter priority)
Radom speed
AF-C (Continous
automatic focus)
or M (manual)
S (singel)
0S
Faster than camera
shutter speed

5.5 Use timer

Before you use the remote for a long exposure time,
make sure that the battery is at full power. When the
display panel flashes the sign for low battery power
(
) you must change the battery before using the
device.

6. Manual release

The remote and the receiver have the same function
as the shutter release button can be found on both
devices.

6.1 Adjust camera settings

Please connect the wireless remote control with your
camera and turn both devices on. Then select the ex-
posure mode, shutter speed, focus mode and shooting
mode as needed.

6.2 Take pictures

Half press the shutter release button and hold it in
this position to start the AF. The indicator light will
flash in orange. Then press it fully down to take the
picture. When the shutter is active, the blue indicator
light will flash and the transmitter makes a "Beep"
every second.
If you want to do a long exposure manually, you
can press the shutter release button of the remote
and slide it up into the hold position. The photo will
be taken as long as the shutter release button is in
this position. Afterwards slide the button back in the
opposite direction to end the exposure.
25

Publicité

Table des Matières
loading

Table des Matières