Axis M11-E Serie Guide D'installation page 16

AXIS M11-E Network Camera Series
Install the Wall Mount
CAUTION
Make sure that the screws and plugs are appropriate for the material (e.g. wood, metal,
drywall, stone) and that the material is strong enough to support the combined weight
of the camera, housing, and wall mount.
Note
• See also the wall mount's Installation Guide supplied in the package and available on
www.axis.com
• For technical specifications about the connectors, see the camera's User Manual available
on www.axis.com
1. Prepare the wall for installation of the wall mount. Use the wall bracket as a template
and mark the holes before drilling the holes.
2. Route the network cable and, if required, the power cable through the wall bracket.
Leave approximately 30 cm (11.8 in) of cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the step above as applicable to the specific device.
4. Fasten the wall bracket to the wall by tightening the screws.
Install the Camera in the Housing
1. Adjust the position of the holder carefully and then tighten the holder screws (torque
0.5 Nm).
NO TICE TICE
NO NO TICE
To fulfill the IK10 rating requirements, adjust the holder's position so that the camera lens
(4) is aligned with the housing edge (3), see the illustration.
16