Axis M11-E Serie Guide D'installation page 14

AXIS M11-E Network Camera Series
Connectors
I/O Connector
4–pin terminal block
For an example diagram, see Connection Diagrams on page 15.
Function Pin
1
0 V DC (-)
2
DC output
3
Digital Input
4
Digital
Output
Power Connector
2-pin terminal block for DC power input. Use a Safety Extra Low Voltage
(SELV) compliant limited power source (LPS) with either a rated output
power limited to ≤100 W or a rated output current limited to ≤5 A.
Notes
Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
Connect to pin 1 to activate, or leave floating
(unconnected) to deactivate.
Connected to pin 1 when activated, floating
(unconnected) when deactivated. If used
with an inductive load, e.g. a relay, a diode
must be connected in parallel with the load,
for protection against voltage transients.
1
2 3 4
14
Specifications
0 V DC
12 V DC
Max load = 15 mA
0 to max 30 V DC
0 to max 30 V DC, open
drain, 100 mA