Kalorik XL DIGITAL SMART FRYER Mode D'emploi page 15

 Clean the heating element inside the Smart Fryer with a cleaning
brush to remove any food residue.
Cleaning the Smart Fryer's exterior
 Wipe clean with a damp sponge or cloth. Wipe dry.
 NEVER use steel wool, metal scouring pads or abrasive cleaners, as
they may damage the finish.
 Do not let any liquids enter the air inlet on the top of the Smart Fryer.
Any other servicing should be performed by an authorized service
representative.
DO NOT IMMERSE THE FRYER IN WATER OR ANY OTHER LIQUID!
TROUBLESHOOTING
Problem
The Smart Fryer does not
work
The ingredients fried with
the Smart Fryer are not
done.
Fried snacks are not
crispy when they come
out of the Smart Fryer.
www.KALORIK.com
Possible cause
The appliance is either
not plugged in or
switched on.
You have not set the
timer.
The basket holder is not
properly locked.
There is too much food
in the basket.
The set temperature is
too low.
The cooking time is too
short.
You used a type of
snack meant to be
prepared in a
traditional deep fryer.
15
Solution
Make sure the main plug is inserted in
an electrical wall socket and press
the On/off key.
Press the timer control buttons to the
required preparation time and press
"On/
Off" again to switch on the
appliance.
Push the basket holder back in the
Smart Fryer properly.
Put smaller batches of ingredients in
the basket. Smaller batches are fried
more evenly.
Adjust the temperature to the
required temperature setting (see
section 'Settings')
Adjust the timer to the required
preparation time (see section
'Settings')
Use snacks made to be prepared in
the oven, or lightly brush some oil
onto the snacks for a crispier result.
FT 43380 - 170120