Other Features - Waldbeck Huygens Mode D'emploi

OTHER FEATURES

Factory Reset/Clear Memory
To restore the console to factory default, perform the following steps:
1. Remove the power from the console by removing the batteries and
disconnecting the AC adapter.
2. Apply power by connecting the AC adapter.
3. Wait for all of the segments to appear on the screen,.
4. Press and hold the WIND/+ and PRESSURE/- keys at the same time until
the console power up sequence is complete (about 5 seconds).
5. Replace the batteries.
Register New Transmitter
Press and hold the LIGHT/SNOOZE button for 5 seconds, and the console will
re-register the wireless sensor.
Backlight Operation
With AC adaptor:
• The backlight can only be continuously on when the AC adapter is
permanently on. When the AC adapter is disconnected, the backlight can
be temporarily turned on.
• Press the LIGHT SNOOZE key to adjust the brightness between High, Low
and Off.
Without AC adaptor:
To reduce power consumption, the display console will automatically enter
sleep mode and will not send data to the Internet if no key is pressed for 15s.
Hold the LIGHT/SNOOZE key in sleep mode or plug in the DC adapter wake up
equipment.
EN
103