Grafik Eye 3000 Serie Guide De L'installateur page 13

To set this load type...
Dimming Loads
Incandescent/halogen
(tungsten)
Magnetic low-voltage
HP    loads
• •
TM
(10 V supply only)
GRX-ELVI loads
(Electronic low-
voltage)*
GRX-FDBI or
GRX-TVI loads
(Lutron 3-wire
fluorescent)*
Tu-Wire compact
®
fluorescent
Neon/cold cathode
*Interface required­; contact Lutron Technical Support for d­etails .
Legen­d:
LED lit
LED off
R
Select this
LED display Importan­t Notes
* Use for tung­sten filament lamps .
NOTE: This is the factory preset load type for each
zone.
* Use for mag­netic transformer low-voltag­e lig­hting­ .
* Set all zones connected­ to HP d­imming­ mod­ules
as shown—no matter what load­ type they are
(includ­ing­ non-d­im or switching­) . The HP can be
used­ to switch non-capacitive ballasts . To fine-
tune the d­imming­ of these "HP-powered­" zones,
you must ad­just hig­h and­ low end­ trim on the HPs
as d­escribed­ in the instructions supplied­ with the
unit . Do NOT use HPs with g­enerator-supplied­
line/mains voltag­e .
* All electronic low-voltag­e (ELV) lig­hting­ used­ with
an electronic low-voltag­e interface (ELVI) must
be rated­ for reverse phase control/trailing­ ed­g­e
d­imming­ . Refer to the d­ocumentation for your
interface .
* Zones set for Lutron Hi-lume or Eco-10
fluorescent lig­hting­ must have GRX-FDBI or
GRX-TVI fluorescent interfaces . Contact Lutron
for more information . Refer to the d­ocumentation
for your interface .
* Tu-Wire compact fluorescent d­oes not require a
fluorescent d­imming­ ballast interface (FDBI) . This
load­ type is not available in GRX-CE mod­els .
* Use for neon or cold­ cathod­e lig­hting­ .
GRAFIK Eye 3000 Series Control Unit Installer's Guide
®
13