Bosch DVA-08E Guide D'installation Rapide page 92

92 en | Connecting a Digital Video Recorder
2.
3.
4.
5.
6.
7.
To configure the DiBos 8:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. On the Start menu, point to All Programs, and then click DiBos. DiBos Explorer opens.
11. In the System menu, click Configuration to open DiBos configuration.
12. In the navigation tree, click Drives and select the drives that store the video data.
13. Click Save.
F.01U.027.800 | V4 | 2008.08
For daisy chaining several subsystems, you must switch off the termination of channel
CH0/1-OUT of all subsystems except the last.
Expand the configuration tree -> click Configuration -> Channel -> Channel 0 or
Channel 1 -> ID Tab -> Termination: Disabled -> Apply.
Click Configuration -> Configuration Parameters -> System tab -> Reset the Controller -
> Apply. The subsystem is reset.
For daisy chaining, change the CH0/1-OUT SCSI channel ID of the second subsystem.
Expand the configuration tree -> click Configuration -> Channel -> Channel 0 or
Channel 1 -> Parameters Tab -> for DVA-08K: clear the 0 and 1 check boxes and select
the 2 and 3 check boxes; for DVA-16K: clear the 0, 1, 2, and 3 check boxes and select the
4, 5, 6 and 8 check boxes -> Apply.
Click Configuration -> Configuration Parameters -> System tab -> Reset the Controller -
> Apply. The subsystem resets.
Click Configuration -> Host LUN Mapping and change to the new ID.
Switch on the subsystem and then the DiBos. The power switches of the subsystem are
located on the rear side of the unit.
In DiBos, log on as Administrator but do not start the DiBos application.
Refer to DiBos Installation Manual for more information.
Click the Windows Start button, and then click Control Panel.
In Control panel, double-click Administrative Tools.
In Administrative Tools, double-click Computer Management.
In Computer Management, click Disk Management. All drives are shown.
Select the drive you want to assign to store video data.
On the Action menu, point to All Tasks, and then click Format to open the Format dialog
box.
In the File system box, click NTFS, and then click OK. The drive is formatted as NTFS.
Make sure that the drives are available. To check the availability, open the Windows
Explorer and click the drives you assigned before.
Quick Installation Guide
RAID Subsystem DVA-08E, -08K, -16K
Bosch Security Systems