Samsung RF261B Serie Mode D'emploi page 15

USING ThE COLD WATER
DISPENSER
Using the Water dispenser
(RF261B)
Place a glass underneath the
water outlet and push gently
against the water dispenser
lever with your glass. Make
sure the glass is in line with
the dispenser to prevent the
water from splashing out.
If you have just installed the
refrigerator or installed a new
water filter, Flush 3 gallons through filter before
use (flush approximately 6 minutes). Make sure
water flows cleanly before drinking.
If you have a long vacation or business trip,
close the water valve and shut off the water
cAutIoN
supply to the Refrigerator. This will help
prevent accidental leakages.
Water clouding phenomenon
All water provided to refrigerators flows
through the core filter which is an alkaline
water filter. In this process, the pressure in
the water that has flowed out of the filter
gets increased, and oxygen and nitrogen
become saturated. When this water flows
out in the air, the pressure plummets and
the oxygen and nitrogen get supersaturated
so that they turn into gas bubbles. The
water could look misty due to these oxygen
bubbles.The water may look temporarily
cloudy due to these oxygen bubbles. After
a few seconds, the water will look clear.
The water tank's capacity is approximately
one third (1/3) of a gallon.
Please wait 1 second before removing the
cup after dispensing water to prevent spills.
DA68-02601B(EN+ES+FR)-0.0.indb 15
PUSh
operating _15
2012.3.29 9:28:43 AM