Before You Start; Inserting The Rechargeable/Conventional Batteries; Charging The Batteries; Preparing The Charging Cradle - SilverCrest SPMR 8000 A1 Manuel D'utilisation

SilverCrest SPMR 8000 A1

Before you start

Inserting the rechargeable/conventional batteries


If necessary, remove the belt clip (see the chapter "Removing the Belt Clip").

Carefully use your fingernail to push the battery compartment cover clip [C] upwards and lift the cover
to remove it.

Insert four AAA-sized batteries/rechargeable batteries into the battery compartment by respecting the
correct polarity. Note the + and – icons on the batteries and inside the battery compartment.

Close the battery compartment. First insert the battery compartment cover on the top into the
corresponding notch on the radio transceiver housing and then swivel the cover downwards until it
clicks into place.

Replace the belt clip (see "Installing the belt clip").

Charging the batteries

If you use rechargeable batteries to power your SilverCrest SPMR 8000 A1 handheld radio transceiver
set, read this chapter carefully.

Preparing the charging cradle

 Place the charging cradle on a stable, flat surface.
 Plug the power adapter plug into the power receptacle [25] of the charging cradle.
 Plug the power adapter into a wall outlet.
14 - English
(The figure is representational)