Installation And Setup; Installation Process - Franklin Electric MONODRIVE UTILITY Manuel Du Propriétaire

INSTALLATION AND SETUP

Installation Process

Refer to the following table when planning installation of the MonoDrive Utility.
1
Plan System
Goals
Intended Function
• Constant
pressure water
systems
Hardware
Application
• Submersible
1. The planned usage of the overall system will determine which options and control methods
are appropriate, as well as how the VFD should be installed and programmed. Refer to the fol-
lowing pages for examples of how the system might be used.
2. System options define and automate features that support the intended operation. These fea-
tures may require specialized control methods and programming. For more details, refer to
"Drive Configuration" on page
3. The MonoDrive Utility supports several methods for automating pump motor speed control.
Refer to "Drive Configuration" on page 22
4. The overall function of the system directly affects where and how the VFD should be mounted.
Refer to "Physical Installation" on page 14
5. The selected motor application, along with the control method(s), determines how the VFD
should be connected. Refer to
6. The VFD can be quickly and easily programmed for most standard operations. Refer to
Configuration" on page
to achieve the desired performance. Refer to
2
Identify Select Control
Options Methods
Automation Pressure Feed-
back Type
• Bump mode
• Steady Flow • Pressure Sensor
• Drawdown
Potentiometer
Protection
• Setpoint value
• Overload • Underload
• Underload Sensitivity
• Motor Ground
Fault
• Drive
Temperature
22, and "Performance Settings" on page
for guidelines.
"Electrical Installation" on page 16
22. Advanced features or options may require additional adjustments
3 4
Install VFD
Hardware
Location
• Inside
• Outside
Climate control
• Temperature
• Moisture
Distance
• Wire sizes
• Filtering
requirements
Measurements
• Clearance
• Drilling
for possible control setups.
for more information.
"Performance Settings" on page
INSTALLATION AND SETUP
Installation Process
5
Install Wiring Program
Parameters
Conduit Basic
• Routing • Application
• Separation • Motor ratings
• Setpoints
High Voltage
I/O setup
• Grounding
• Inputs • Input functions
• Outputs
Option settings
Control circuits
• Enable features
• Feedback
inputs
24.
"Drive
24.
6
11