Axis Communications Q60 Serie Guide D'installation page 18

AXIS Q60 Series
8. Connect the network cable to the camera.
NO TICE TICE
NO NO TICE
Be careful not to damage the network cable when connecting it.
9. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
10. Secure the network camera to the mounting bracket by tightening the screws.
4
3
1
Screw T30 (3x)
2
Slot for unit holder (3x)
3
Safety wire
4
Wall bracket (mounting example)
11. Install the supplied midspan. See page 18.
Install the Midspan
The supplied midspan enables Axis network video products with high power consumption to receive
data and power over the same network cable.
1. Connect the midspan (data in) to the network switch using a network cable.
2. Connect the midspan (data and power out) to the camera using the network cable that
has been connected to the camera.
3. Connect the midspan to a grounded (earthed) mains power outlet (100–240 V AC) using
the supplied power cable.
18
1
2