Riello Elettronica CARDIN PRG384 Mode D'emploi page 9

Container installation procedure
4A
• Remove the screws "B" and carefully extract the
P.C.B. card "C" from the container remember-
ing to store it somewhere safe from dust and
possible damage.
4B
• Using the container as a template mark the four
points at which the fastening holes are to be
drilled;
• Fasten the container using four screws and raw
plugs "G" and insert the screw covering plugs
"H".
• Insert the pipe fittings "D"
that they are fastened correctly.
4C
• Re-insert the electronic card into the container
and fasten down using the screws "B"
• Insert the rigid electrical connection pipes "I"
into the cable tubes. The 400V3 power cables
should be passed through pipes 1 and 2 (see
figure) so as to separate them from the low
voltage wires which should be passed through
pipes 3 and 4.
• Carry out the electrical connection following the
attached wiring diagram (see fig. 5).
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
Drawing number :
Product Code :
Draft : P.J.Heath
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
(fig.4A)
and check
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
(fig.4A)
Drawing number :
DM0135
Product Code : LPRG
Draft : P.J.Heath Date :
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
9
Description :
DM0138
Inserimento scheda PRG383
PRG
Date : 27-04-98
Description :
Installazione contenitore PRG
27-04-98
A
D
C
E
F
H
G
M
1 3 0 M
1
2
3
4
4
B
I