Switching Off A Burner; Power Levels; Operating And Residual Heat Indicator; Protection Against Overheating - NEFF T26R46 Serie Notice D'utilisation

Switching off a burner

Turn the corresponding control knob clockwise to the 0 setting.
Automatic off
After six hours of operation, the appliance switches off
automatically. Turn all control knobs to setting 0; the appliance
can now be switched on again.

Power levels

The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Setting Ú Control knob off
High flame › Maximum capacity or aperture and elec-
tricity on
œ
Low flame Minimum capacity or aperture
For dual double-flame burners, the inner and outer flames can
be controlled separately. The available power levels are as
follows:

Operating and residual heat indicator

All the hotplates have an operating and residual heat indicator
which comes on when the flame on the corresponding hotplate
is lit.
Once the hotplate is switched off, the residual heat indicator
remains on indicating that the hotplate temperature is too high.
Do not touch the hotplate while the indicator light is on.
After a while the residual heat indicator will go off, indicating
that the temperature of the hotplate has dropped and is no
longer too high. Care must then be taken when touching the
appliance to avoid burns, since the hotplate may not have
completely cooled down.

Protection against overheating

The hob has a protection against overheating system to protect
the electrical installation. This switches off all the burners in
case of overheating and the operating indicators start to flicker.
Turn all control knobs to setting 0. Wait until the appliance has
cooled down sufficiently. Now you can reconnect the appliance
normally. The rapid flickering of the burner operation indicators
switches off or is replaced by the residual heat indicator.
14
Inner and outer flame on full
power.
Outer flame on minimum, inner
flame on full power.
Inner flame on full power.
Inner flame on minimum
power.

Warnings

This appliance will not function if it is not connected to the
mains or if the electricity supply is cut off.
It is normal to hear a soft whistling noise while the burner is
operating.
When first used, it is normal for the burner to give off odours.
This does not pose any risk and does not indicate a
malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by the
presence of dust in the atmosphere, spilt liquids, etc.
Keep the burner as clean as possible. If the ignition sparkers
are dirty they will not light properly. Clean them periodically
using a small non-wire brush. Bear in mind that the ignition
sparkers must not suffer any serious impacts.

Cooking guidelines

Burner Very high - High
Wok burner Boiling, steam-
ing, griddling,
toasting, paellas,
Asian food (wok).
Rapid burner Escalopes,
steaks, ome-
lettes, frying
Semi-rapid Steamed pota-
burner toes, fresh vege-
tables, vegetable
stews, pasta
Auxiliary Cooking: casse-
burner roles, rice pud-
ding, caramel
Medium Low
Reheating and keeping
things hot: cooked and pre-
cooked dishes
Rice, white Steaming:
sauce, ragout fish, vegeta-
bles
Reheating, keeping things
hot and making tasty casse-
roles
Defrosting Melting: but-
and slow ter, choco-
cooking: veg- late, jelly
etables, fruit
and frozen
products