Installation Of The Carbon Filter; Cleaning And Maintenance - Klarstein SECRET SERVICE Mode D'emploi

EN
28

Installation of the carbon filter

Activated carbon filter can be used to trap odors. Normally the activated carbon
filter should be changed at three or six months according to your cooking habit.
Activated carbon filter cannot be washed or recycled. The installation procedure of
activated carbon filter is as below.
Inserting the activated carbon filter
Remove the filters as shown in the
picture.

CLEANING AND MAINTENANCE

The cleaning of the carbon grease filter mesh
The filter mesh is made of high-density stainless steel. Please do not use the
corrosive detergent on it. Keeping this filter clean will keep the appliance running
correctly. Please strictly follow the guidelines below.
Method 1:
Put the mesh into 40-50 °C clean water, pour on detergent, and soak for 2-3 mins.
Wear gloves and clean with a soft brush. Please do not apply too much pressure,
as the mesh is delicate and will damage easy.
Method 2:
If instructed to do so, it can be put into a dishwasher, set the temperature at
around 60 degrees.
The carbon filters are located at
either end of the motor. Turn the
charcoal filters anti- clockwise until
they are unscrewed. Apply reverse
procedure to install the char- coal
filter.