Technical Data - Transistor Lynx Door Transmitter Manuel

ENGLISH
Changing the channel setting
The door transmitter sends signals wirelessly to the receiver installed in the Lynx
system. It can transmit on a total of 16 different channels (0-9, A-F). Channel 0 is
reserved for a common fire alarm and should not be used. Transmitters and receiv-
ers in the system must be set to the same channel so that they can communicate.
They are all pre-set to channel 9, and then operate together without alteration.
In some cases, it may be necessary to change the channel setting. If two or more
users live near one another, the alarms can interfere. This can be rectified by
changing the channel settings so that they are different for everyone. Any channel
can be selected except Channel 0.
If you need to change channels on the receiver, see the receiver user manual. If
you need to change the channel on the door transmitter, proceed as follows:
The channel selector is on the rear.
Carefully release the plastic
protection over it.
Use a small screwdriver and turn the
yellow arrow towards the required
channel. Refit the plastic protection
over the channel selector.

Technical data

Modulation:
Frequency:
Power supply:
Service life:
Range:
Channels:
Dimensions:
Weight:
Any issues relating to the EU Medical Device Directive
93/42/EEC should be directed to AB Transistor Sweden.
6
AM.
433.92 MHz.
3 V lithium battery. WARNING: Risk of explosion
if fitted incorrectly!
Approx 5 years (with 3 alarms per day).
Maximum 70,000 alarms.
Up to approx. 30 m indoors.
16.
60 x 40 x 23 mm.
35 g.