Battery Warning; Changing The Battery - Transistor Lynx Door Transmitter Manuel

When the doorbell rings
When someone rings the doorbell, the receiver installed in the Lynx sys-
tem will be activated and will issue a warning by vibration and symbols,
loud noise, or flashing light, depending on the type of receiver.
Read the user manual for the receiver installed!

Battery warning

The door transmitter is powered by a battery with a normal service life
of approximately 5 years. When battery power begins to fail, the door
transmitter will send out an alert. It sends a flat-battery warning along
with the alarm to the receiver in the alerting system.
Read the user manual for the receiver installed!

Changing the battery

1. Unscrew the two screws on the
rear of the door transmitter, and
release the rear cover by lifting it
straight up.
2. Carefully push the old
battery out of the holder.
3. Replace the battery with a new
CR2032 Duracell type battery.
Note: The battery's positive
terminal must be facing up-
wards.
4. Screw on the rear cover.
ENGLISH
1.
2.
5