Installation - AKG C562 CM Mode D'emploi

4 Installation

Fig. 2: Installing the micro-
phone in a boundary.
IMPORTANT
Refer to fig. 2.
14
You can install the microphone in a panel with a maximum thickness of 6/8" (19 mm).
1. - 2.
b b
a
a
c
c
• To ensure proper functioning, make sure that the microphone body will not
make contact with any grounded metal parts.
1. Drill a hole ½" (12.5 mm) in diameter in the boundary (a).
2. Thread the cable (b) though the hole from the front and push the microphone (c) all the
way in.
3. Press the microphone (c) against the boundary (a).
4. Slip the knurled nut (d) over the jack plug and cable and onto the microphone shaft (e).
5. Tighten the knurled nut (d) to the point that the microphone (c) is firmly held in place.
3. - 4.
d
d
e
e
c
a a c
5.
d
d
c c
C 562 CM