Tilting Up And Down - Yamaha Motor VF150 Serie Manuel De L'utilisateur

bow up, the boat may have a greater tenden-
cy to steer to one side or the other. Compen-
sate for this as you steer. When the bow of
the boat is down, it is easier to accelerate
from a standing start onto plane.
Bow Up
Too much trim-out puts the bow of the boat
too high in the water. Performance and econ-
omy are decreased because the hull of the
boat is pushing the water and there is more
air drag. Excessive trim-out can also cause
the propeller to ventilate, which reduces per-
formance further, and the boat may "por-
poise" (hop in the water), which could throw
the operator and passengers overboard.
Bow Down
Too much trim-in causes the boat to "plow"
through the water, decreasing fuel economy
and making it hard to increase speed. Oper-
ating with excessive trim-in at higher speeds
also makes the boat unstable. Resistance at
the bow is greatly increased, heightening the
danger of "bow steering" and making opera-
tion difficult and dangerous.
TIP:
ZMU07038
Depending on the type of boat, the outboard
motor trim angle may have little effect on the
trim of the boat when operating.
EMU27948
If the engine will be stopped for some time or
if the boat is moored in shallows, the out-
board motor should be tilted up to protect the
propeller and lower case from damage by
collision with obstructions, and also to re-
duce salt corrosion.
EWM01544
WARNING
Make sure that all people are clear of the
outboard motor when tilting the outboard
motor up and down. Body parts can be
crushed between the outboard motor and
the clamp bracket when the outboard mo-
tor is trimmed or tilted.
ECM00993
ZMU07039
NOTICE
 Before tilting the outboard motor, follow
the procedure under "Stopping engine"
in this chapter. Never tilt the outboard
motor while the engine is running. Se-
vere damage from overheating can re-
sult.
Operation

Tilting up and down

ZMU07040
63