Operation; Start-Up; Decommissioning; Storage - Carl Roth CR-KP292 Mode D'emploi

Installation and Operation
Use only for compressed air applications suitable conduit systems!
5.3

Operation

Observe the basic safety instructions when using the Piston Pump, chapter 2.
5.3.1

Start-up

Make sure that when you start the pump, which may arise in the connection lines con-
densates, cannot penetrate into the pump.
Always try to avoid aspiration of foreign body particles!
The Piston pump is switched on using the power switch.
It is recommended to let the pump run for a few minutes before use. The warm-up im-
proves the eligibility of the pump.
5.3.2

Decommissioning

If vacuum applications with special steam load, the pump needs to run after the process
with an open vacuum port about 2 minutes and rinsed with atmospheric air.
This measure is used to cleaning the pump chamber and minimizes the corrosive attack
wetted material pump parts.
The Piston pump is switched off using the power switch.
5.4

Storage

The pumps are to be stored in a low-dust, interior room within the temperature range from
+ 5 to + 40 °C and at a relative air humidity < 90%.
Leave the protective elements on the suction and pressure ports. Another equally good pro-
tection may be used.
5.5

Scrap Disposal

The Piston Pump must be disposed of in accordance with the 2012/19/EC guideline
and the specific national regulations.
Contaminated Piston Pumps must be decontaminated according to the laws.
12
CAUTION !
CAUTION !
CAUTION !