JB Systems DYNASPOT Mode D'emploi page 8

ENGLISH
Temperature inside the unit [tEMP]
Used to show the temperature inside the unit
 Press the MODE and UP/DOWN buttons until the display shows "tEMP".
 Press the ENTER button to show the internal LED temperature of the unit on the display.
 To go back to the functions press the MODE button again.
If you want to go back to normal running mode: press the MODE button for about 2 seconds.
Fixture Time [FHrS]
Used to show the number of working hours of the unit.
 Press the MODE and UP/DOWN buttons until the display shows "FHrS".
 Press the ENTER button to show the number of working hours in the display.
 To go back to the functions press the MODE button.
Firmware version [VEr]
Used to show the software version that is installed in the unit
 Press the MODE and UP/DOWN buttons until the display shows "VEr".
 Press the ENTER button to show the software version on the display.
 To go back to the functions press the MODE button.
Defaults [dEF]
Used to choose between 3 sets of default parameter settings.
 Press the MODE and UP/DOWN buttons until the display shows "dEF".
 Press the ENTER button:
 Use DOWN and UP buttons to select one of the options:
 PRO-defaults [PrO] : loading basic settings for use on DMX-controllers.
 AUTO-defaults [AUtO] : loading basic settings for easy master/slave use.
 USER-defaults [USEr] : saving or loading your own preferred settings.
PARAMETER name
ChMd – DMX Channel mode
ShMd – Show mode
SLMd – Slave mode
bLMd – Blackout mode
SoSE – Sound sensitivity
IPAN – PAN inversion
ItLt – TILT inversion
Led – Display on/off
DISP – Display upside down
 Press the ENTER: the display shows "LOAd" (or "StOr" *). To avoid accidental loss of your settings you
have to confirm the action: use DOWN and UP buttons to select "Yes" or "No" and confirm by pressing the
ENTER button.
 Press the MODE button for about 2 seconds to store the setting and to return to running mode.
REMARK (*): When "USER-defaults" is selected you can also choose to store the current settings of the
setup menu: use the UP/DOWN buttons to choose [StOr] "store" on the display.
Reset [rESt]
Used to force a reset of the unit.
 Press the MODE and UP/DOWN buttons until the display shows "rESt".
 Press the ENTER button to reset the unit.
REMARK: also check the chapter about the DMX-channel configuration of the unit to find out how you can
force a reset by DMX.
JB SYSTEMS
®
PRO defaults AUTO defaults
10 ch
Sh 1
SL 1
Hold
60
oFF
oFF
oFF
oFF
6/59
USER defaults
5 MSL Personal user setting
Sh 1 Personal user setting
SL 1 Personal user setting
Soun Personal user setting
60 Personal user setting
oFF Personal user setting
oFF Personal user setting
on Personal user setting
oFF Personal user setting
USER MANUAL
DYNASPOT