JB Systems DYNASPOT Mode D'emploi page 10

ENGLISH
 Set the master to 5MSL channel mode (see previous chapter). Check the DMX-chart below to see the
difference between both channel modes.
 For the DMX-controller the master and his slaves can now be considered as 1 virtual effect that needs a
start address so it can be controlled as any other DMX-unit in the DMX chain: see "DMX Address" in the
chapter "Main Menu" to see how you can set the DMX-start address.
 Make sure that all units are connected to the mains.
 Set the DMX-controller according to the DMX-chart below.
 Done!
Remark: in order to work well to the rhythm of the music, make sure to set the blackout mode [BLMd] of
the MASTER projector to "SOUN" and sound sensitivity [SOSE] to a value over 50 (see previous chapter).
DMX-Chart for 5MSL working modes
1 – DIM
VALUE FUNCTION VALUE
255 100%
10
9
8
7
6
5
4
3
008 0%
2
000-007 STANDBY
1
Electrical installation in DMX-mode:
 The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected units with a good quality balanced cable.
 Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these
cables are compatible with balanced audio cables.
Pin layout XLR-3pin:
Pin layout XLR-5pin:
 To prevent strange behavior of the light effects, due to interferences, you must use a 90Ω to 120Ω
terminator at the end of the chain. Never use Y-splitter cables, this simply won't
work!
 Make sure that all units are connected to the mains.
 Each light effect in the chain needs to have its proper starting address so it knows
which commands from the controller it has to decode. In the next section you will
learn how to set the DMX addresses.
HOW TO SET THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit.
The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user
manual which starting addresses you have to set because this completely depends on the controller you will
use... So please refer to the user manual of your DMX-controller to find out which starting addresses you
must set.
JB SYSTEMS
®
2 - STROBE
FUNCTION VALUE
255 FAST STROBE
218-255
188-217
158-187
128-157
098-127
068 SLOW STROBE 068-097
038-067 SOUND STROBE 038-067
008-037 RANDOM STROBE 008-037
000-007 OPEN 000-007
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5 not used.
3 - COLOR 4 - GOBO
FUNCTION VALUE
ORIGINAL
218-255 ORIGINAL GOBOS
COLORS
COLOR 7 188-217
COLOR 6 158-187
COLOR 5 128-157
COLOR 4 098-127
COLOR 3 068-097
COLOR 2 038-067
COLOR 1 008-037
WHITE 000-007
8/59
USER MANUAL
5 - PAN/TILT SPEED
FUNCTION VALUE FUNCTION
255 AUDIO FAST
GOBO 7
GOBO 6
GOBO 5
GOBO 4 AUDIO TRIGGERED
GOBO 3
GOBO 2
GOBO 1 008 AUDIO VERY SLOW
NO GOBO 000-007 HOLD (FREEZE)
DYNASPOT
RANDOM
PROGRAM