To Install Your Beberage Cooler - IO Mabe IOB150BB Manuel D'utilisation

TO INSTALL YOUR BEBERAGE COOLER

This Beverage cooler is designed for free standing or built-in (fully recessed) installation.
Place your Beverage cooler on a solid and level floor that is strong enough to support it when
it is fully loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling
legs in and out to stabilize the cooler horizontally. If the legs are not properly adjusted, the
cooler may be unstable and result in excess noise or vibration.
Locate the Beverage cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also cause the cooler not
to perform properly.
It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as
moisture could cause premature corrosion to the components of your new cooler.
It is recommended you install the Beverage cooler in a place with temperatures above 50°F
(10°C) and below 90°F
above or below recommended temperatures, the performance of the cooler may be affected.
Placing your cooler in extremely cold or hot conditions may cause interior temperatures to
fluctuate, and the temperature range of
Connect the Beverage cooler to an exclusive, properly grounded, standard electrical supply
(220 V AC only, 50
ordinances. Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorized products service center.
Warning:
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord
is damaged, have it replaced by an authorized service center.
The Beverage cooler should always be plugged into its own individual electrical outlet which The Beverage cooler should always be plugged into its own individual electrical outlet which
has a voltage rating that matches the rating label on the Beverage cooler. This provides the has a voltage rating that matches the rating label on the Beverage cooler. This provides the
best performance and also prevents overloading house wiring circuits that could cause a fire best performance and also prevents overloading house wiring circuits that could cause a fire
hazard from overheated. hazard from overheated.
(32°C), and humidity is under 60%. If the ambient temperature is
Hz), in accordance with the National Electrical Code and local codes and
2ºC-18ºC (36ºF-65ºF)
may not be reached.
5.